Re: Swapping engines/G2/G9/G8/G14
 

Sorry I didn't reply sooner, check out your new post.

Re: Swapping engines/G2/G9/G8/G14
 

Doing G2 engine swap into G11. Notice significant difference in spark triggering "area", def not compatible. They did not follow my instructions to swap Everything to new motor from old motor, now im finishing the job (after their work trying to get it to run eventually killed the coil, incorrect dwell is my guess).

Re: Swapping engines/G2/G9/G8/G14
 

So I have a g9 with a locked up engine, and a spare g2 engine. Is this swap plug-and-play? All I have from the g2 is the engine, no harness or anything

Re: Swapping engines/G2/G9/G8/G14
 

It is just plug and play in your case:thumbup:

Re: Swapping engines/G2/G9/G8/G14
 

Can you put a G8 engine in a G2 cart??

Re: Swapping engines/G2/G9/G8/G14
 

Swap all the ignition parts from the old motor, and swap the flywheel from the old motor onto the G8 motor. Then it will be a breeze... 8) See my post above about the flywheel, it must have its matching pulser, and they both must be matched to the correct ignitor (electronic ignition box). All the needed parts from the G2 motor bolt right on the G8 motor. Important- Use a steering wheel puller on the 3 bolt holes on the flywheel, Do not use a big "jaw puller" on the outside edge of the flywheel. You can see the puller i used in the photo behind the flywheels.

Re: Swapping engines/G2/G9/G8/G14
 

Cborkowski u can make it work ;)

Re: Swapping engines/G2/G9/G8/G14
 

Can a G8 motor fit into a gen 1 yamaha ?

Re: Swapping engines/G2/G9/G8/G14
 

Found my answer :)

Re: Swapping engines/G2/G9/G8/G14
 

G16 to G22???? Or a JN6 engine to a cart with a JR6 engine???
Thanks.
They look the same.