2005 ezgo 2 stroke will start but not move
 

The engine starts when pressing the gas pedal but the engine will only sometimes kick in high enough rpm's to move the cart. The gas filter appears to be clean. Need advise pleae.

There are two cables from the gas pedal. One is connected to the carb and one is disconnected. I think this is the governor? Does it need to be attached?

What is the ideal oil gas mix ratio for this cart? Do you recommend highest octane gas?

Thank you!

Re: 2005 ezgo 2 stroke will start but not move
 

2005 2 stroke? really?
Maybe it is a 4 stroke. Does it have a dip stick or oil in the crank case ?

Re: 2005 ezgo 2 stroke will start but not move
 

I have to agree Scotty It's either a 4 stroke or it's not a 2005 can you send us a pic. of the cart and the cables you are referring to?

Re: 2005 ezgo 2 stroke will start but not move
 

See below

Re: 2005 ezgo 2 stroke will start but not move
 

will get a photo. the serial number is 266505 code HOT82

Re: 2005 ezgo 2 stroke will start but not move
 

I have attached pictures. Two cables are at bottom center of first pic. One attached to carb, the other is not attached to anything. Thank you!

Re: 2005 ezgo 2 stroke will start but not move
 

Okay well she is an 82 not 05 ... must have been a bit of a disappointment to learn :lhmo:

Really now, the 2 cables to the carburetor should be the throttle and the choke. Beyond that ???

Sorry I'm short on experience with old 2 strokes, perhaps somebody with more experience here will chime in. 8)

Re: 2005 ezgo 2 stroke will start but not move
 

Gotcha covered on this one Scotty B. The 2nd cable from the pedal is the Governor cable.