any ideas?
Ok, So i just installed the alltrax 400, new solenoid, and 2 gauge battery cables into my 2015 precedent.... everything is working well except when i plugged my car in to charge. It wouldn't do the 3 beeps that it has always done??? it was charged this morning but just confused as to why that would stop. any ideas?
Thanks! |
Re: any ideas?
The 3 beeps, and the operation of the battery lamp on the dash are functions of the stock Curtis controller, which you removed.
The Alltrax doesn't do the 3 beeps, and it is not connected with the battery lamp on the dash. Mostly because those are non-necessary functions. Install a digital volt meter (with numbers, Not the bar graph) so you know when your batteries are getting low based on voltage. |
Re: any ideas?
Amen to that !
|
Re: any ideas?
Quote:
|
Re: any ideas?
With the new 2ga cables. How did you run the cable through the OBC
|
Re: any ideas?
Quote:
|
All times are GMT -5. The time now is 10:29 PM. |
Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
This Website and forum is the property of Buggiesgonewild.com. No material may be taken or duplicated in part or full without prior written consent of the owners of buggiesgonewild.com. © 2006-2017 Buggiesgonewild.com. All rights reserved.