priming fuel on 83 G1
How do you prime a fuel pump on a G-1 golf cart that ran out of gas, cannot get gas pumping.
|
Re: priming fuel on 83 G1
I just finished a engine rebuild and all I done was take off the fuel line from the top of the tank and got a squeeze bottle and put gas down into the gas line till it was full. I then hooked the line back to tank spilled a bit but not a big deal, then started it right up. Hope that helps but I am sure there could be a easier way and I am sure someone on BGW will tell you. good luck.
|
Re: priming fuel on 83 G1
I take the line off the carb, the cap off the tank & put air to it you'll notice right away gas flowing from the hose. just don't put very much pressure in the tank.
|
Re: priming fuel on 83 G1
My tank has a small rubber vent cap on top, I pulled it out and stuck a clean gas line in the hole and blew in it till gas came out the fuel pump supply nipple
|
Re: priming fuel on 83 G1
Installed hand pump primer connected to fuel line. Made all the difference for mine
|
All times are GMT -5. The time now is 12:54 PM. |
Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
This Website and forum is the property of Buggiesgonewild.com. No material may be taken or duplicated in part or full without prior written consent of the owners of buggiesgonewild.com. © 2006-2017 Buggiesgonewild.com. All rights reserved.