Re: Club Car Speed link 4 Precedent Golf Cart SpeedyLink
cc-101920101 3pin plug & wedge lock
cc-101942301 3pin recept & wedge lock these do not come with the pins |
Re: Club Car Speed link 4 Precedent Golf Cart SpeedyLink
1 Attachment(s)
Quote:
i speculated one these could be built with a 4000 series logic ic back a few months or so ago. link. my cart is a series cart, so i never built one up to test. but ya, i picked the CD4013BE because of it's 18v limit. do the connectors have a manufacturer's name/part number stamped on them? if they are the same manuf as the mcor plug, i helped someone here source the pins sometime back. i'll try to dig it up. the other thought i had was to use a µC with a pot or rotary encoder to make the amount of "boost" continuously variable. it could even be used to limit the speed below 12mph for kids or other liability concerns. good stuff! -sj |
Re: Club Car Speed link 4 Precedent Golf Cart SpeedyLink
Mine has a switch connector for mode select if your cart is mode 2 then you will have either mode 2 or 4 if its set up for mode 3 then you will have 3 and 4
18 volts chip is a great idea. I was to excited to do any more research!! just had to build it, and had the regulators on hand. now Im looking for 30 mph |
Re: Club Car Speed link 4 Precedent Golf Cart SpeedyLink
I found the pins in wash state had to buy 25 of each male - female
deutsch connector DT04-3P and club car was as cheep as it gets on these connectors (without pins) how can you sell a plug without pins??? |
Re: Club Car Speed link 4 Precedent Golf Cart SpeedyLink
Quote:
30 is my goal as well... seems like a reasonably safe top speed for on-road use. Quote:
|
Re: Club Car Speed link 4 Precedent Golf Cart SpeedyLink
Quote:
|
Re: Club Car Speed link 4 Precedent Golf Cart SpeedyLink
Sonicj
Mine means my design, I am not selling anything, I freely gave the schematic and prototype layout. 2 plugs (you hate) 1 perf board 3.00 1 390 chip 2.50 1 5 volt reg 2.00 1 resistor .50 1 cap .50 3 wire 4.00 less than 30$, now if you could come up with a higher voltage divide chip it could be wired right to the chip and then potted. and your correct loose the connector and this thing would be lots cheaper but then if something goes wrong it would not be as easy fix, pull it out and just plug it in back to stock. and quit shooting trash cans they leak when you do that!!!! |
Re: Club Car Speed link 4 Precedent Golf Cart SpeedyLink
GolfDog
Real nice find on the connectors!! I have saved this site, I like the layout and ease of use also great find. Thanks Larry |
Re: Club Car Speed link 4 Precedent Golf Cart SpeedyLink
sonicj You got a pic of the back of your cir board?
2007 Club Car Precedent, try'n to build one of your board but can't seem to find the parts @ radio shack. Part list 1 perf board (got it) 1 390 chip (radio shack #)? 1 5 volt reg (radio shack #)? 1 resistor (radio shack #)? 1 cap (radio shack #)? 3 wire (got it) |
Re: Club Car Speed link 4 Precedent Golf Cart SpeedyLink
You can get the 74hc390 at jameco, mouser or digikey not sure about RS.
|
All times are GMT -5. The time now is 04:08 AM. |
Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
This Website and forum is the property of Buggiesgonewild.com. No material may be taken or duplicated in part or full without prior written consent of the owners of buggiesgonewild.com. © 2006-2017 Buggiesgonewild.com. All rights reserved.