Dash cover will not cover
I am trying to install a dash cover on a 00 EZGO Workhorse and am having tremendous difficulty. It is a very tight fit around the cup holders. Is there a trick to make it completely slide over the cup holders? It almost seems like the dash cover was formed wrong. There is a 1'' gap between the key switch plate and the dash cover no matter how hard I push. :? Any tips/suggestions? Thanks
|
Re: Dash cover will not cover
I finally got it to slip over the cup holders but now my little fingers hurt. :lol: I assume by the 2 holes in the dash cover and the gap between it and the old dash that the key switch plate needs to be removed and mounted to the dash cover. The key switch plate has 2 lips on the top to hold it in place. Why can't I get it to catch on the dash cover? Is it suppose to?
Where are the correct locations to drive the screws through? |
Re: Dash cover will not cover
I am thinking of buying a stretch plastic dash cover. I wondered how the fit and finish is? My dash where the molding meets the body is gaulged pretty deep in a couple spots. I was hoping one of these would cover that up. Can you even see the old dash or does it complete cover and lay flush to the body?
Thanks Ralph |
Re: Dash cover will not cover
:evil:over the cupholders...is that right? It just sounds wrong, I had to remove my stock cupholders but it should be very obvious.
|
Re: Dash cover will not cover
Can someone show me a picture of one installed from the front looking down on it?
|
All times are GMT -5. The time now is 03:40 AM. |
Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
This Website and forum is the property of Buggiesgonewild.com. No material may be taken or duplicated in part or full without prior written consent of the owners of buggiesgonewild.com. © 2006-2017 Buggiesgonewild.com. All rights reserved.