|
Arcing from #6 neg terminal?
I just replaced the batts and cables on my 02 48 volt club car and now when i press the pedal it sparks from the #6 neg terminal? I know they are hooked up right so why is it doing this? also it acts like its not taking a charge. thanks
|
Re: Arcing from #6 neg terminal?
Sparks generally indicate a bad connection. You may have a bad cable. It is always a good idea to change your cables when you change your batteries. I would also check again to see for sure that all the batteries are neg to pos all the way through the set. How is it acting like it won't take a charge?
|
Re: Arcing from #6 neg terminal?
I did replace the cables. charged it and it ran down the drive way then quit? now the charger wont come on.
|
Re: Arcing from #6 neg terminal?
Quote:
I would double check the battery wiring for proper connections. It just sounds like a battery is in backwards. |
Re: Arcing from #6 neg terminal?
Check small gage red wire that is connected to last battery to charger plug.
|
Re: Arcing from #6 neg terminal?
From what i can gather the OBC/charger look for a minimum of 40 volts to come on
|
Re: Arcing from #6 neg terminal?
If you have sparks coming from #6 battery terminal there is an improper connection of some kind.
|
Re: Arcing from #6 neg terminal?
Look for loose cables in lugs, frayed wires, wire strands sticking out of lug, darkening around lugs
|
| All times are GMT -5. The time now is 06:43 PM. |
Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
This Website and forum is the property of Buggiesgonewild.com. No material may be taken or duplicated in part or full without prior written consent of the owners of buggiesgonewild.com. © 2006-2017 Buggiesgonewild.com. All rights reserved.