Electric Lift for Workhorse dump bed
2 Attachment(s)
Don’t know if this is worthy of a sticky?
Electric lift for workhorse dump bed components that will seamlessly fit factory mounts. Warner Electric liner actuator# K2xG20 (2200 lb cap, 6” throw) You can use any that is 14” to 15” closed dimension. Napa switch# TG7071 (Momentary on /off/ momentary on 6 pole) Napa 30amp breaker# 782-3105 1) ½” x 3” clevis pin 1) ½” x 1-7/8 to 2” clevis pin 2) 3/8” spacers (I used 1/2" SAE washers) 3) cotter pins (appropriately sized for clevis pins) Red and black primary wire, I used 14 gauge about 15’ ea. 15’ 1/2” split loom cut to length. cost me ttl $143.00 |
Re: Electric Lift for Workhorse dump bed
Sticky
|
Re: Electric Lift for Workhorse dump bed
Where did you get the actuator from?
I'll make this a sticky or part of one asap. |
Re: Electric Lift for Workhorse dump bed
Ruredy,
I got mine on e-bay real cheap. You would have to find a Warner distributor to buy them retail. I also think the Northern Tool Item# 125011 will work, I just thought it was kind of cheap looking. |
Re: Electric Lift for Workhorse dump bed
Jon,
This is the Warner page for the actuator. They have a link on top for dealer locator. http://www.warnernet.com/newproducts...gory=actuators |
Re: Martini Time No Subject
3 Attachment(s)
Switch wiring for ez-go dump:thumbup:
|
All times are GMT -5. The time now is 02:30 AM. |
Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
This Website and forum is the property of Buggiesgonewild.com. No material may be taken or duplicated in part or full without prior written consent of the owners of buggiesgonewild.com. © 2006-2017 Buggiesgonewild.com. All rights reserved.