|
91 ezgo runs when jacked up wont go on the ground
Have a 91 ezgo just replaced the batteries controller solenoid and wires. Was running weak after i put the new controller and so bought new batteries. But now it will only run if i jack it up. Tired of buying parts and need help figuring out whats wrong what is my next step to find out whats wrong. Any help is appreciated
|
Re: 91 ezgo runs when jacked up wont go on the ground
Im going with a weak connection at the F&R switch , or motor brush problems. But, this might seem obvious, since you replaced everything else first.
|
Re: 91 ezgo runs when jacked up wont go on the ground
Any way to check that?
|
Re: 91 ezgo runs when jacked up wont go on the ground
A lousy motor might still pass the tests shown on the site, inspect both (remove, disassemble). check volts @ motor on jack stands, then compare volts @ motor on ground under real load. With test leads at same spots both times. If volts @ motor are far lower under load, a bad connection elsewhere is likely the problem.
|
| All times are GMT -5. The time now is 07:51 PM. |
Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
This Website and forum is the property of Buggiesgonewild.com. No material may be taken or duplicated in part or full without prior written consent of the owners of buggiesgonewild.com. © 2006-2017 Buggiesgonewild.com. All rights reserved.