|
lots of pics/lots of questions txt belt, hei conversion, general info
5 Attachment(s)
First off I would like to say this site is awsome. I have found much info that is very helful and appreciate everyones help.
Ok Well i have a 99 Ezgo TXT, and a lot of questions to go with it. I bought a new belt for it and would like to know if it is supposed to be as loose as it is. Also I have no spark, well I have a spark twice when I first his the gas pedal and then no more. When I got the cart it was missing the dual coil, I bought a new one and put it on. The pulsar coil seemed to check out in the ohms area. So I am guessing that it is the igniter. I want to do the hei conversion but the wiring diagram on the site shows it for the single coil and different colored wires. I am looking for any info on doing this, I have supplied a pic of the wires that I have that need to be hooked back up. I jsut need to know where they should all go. I also have a problem putting my flywheel cover back on, the coil seems to be in the way, I don't know if this is the right location but is has the right holes, and is the only place that all the wires will reach, the coil is most definetly in the way, since it was not on it before the cover mounted fine. Any help would be greatly appreciated. I will have plenty more questions I am sure |
Re: lots of pics/lots of questions txt belt, hei conversion, general info
The coil is in the right location, you just need to put the flywheel cover on first then coil. Not sure on the HEI upgrade though. The driven clutch looks to be stuck open. The belt is supposed to ride at the top of the clutch in the rear.
|
Re: lots of pics/lots of questions txt belt, hei conversion, general info
Ok so if the back clutch is stuck, that would explain the slack in the belt, but does it look as if it is riding in the right spot in the front clutch? Thanks
|
Re: lots of pics/lots of questions txt belt, hei conversion, general info
The drive clutch (front) is normally open and closes as the engine increases in rpm. The driven clutch (rear) is normally closed and opens as the engine rpm is increased.
|
| All times are GMT -5. The time now is 12:40 AM. |
Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
This Website and forum is the property of Buggiesgonewild.com. No material may be taken or duplicated in part or full without prior written consent of the owners of buggiesgonewild.com. © 2006-2017 Buggiesgonewild.com. All rights reserved.