2013 Ezgo Rxv handle code help! Throttle wiper/brake wiper
I am working on 2013 rxv. Bought a Curtis handheld 1313-4331 to hookup to cart to get the codes. The codes and I am getting are brake wiper and throttle wiper. The cart starts its self test when you turn the key on but will not do anything. I read some other threads that had same problem but never seen a solution. I have swapped the control out with another controller and nothing changed.
|
Re: 2013 Ezgo Rxv handle code help! Throttle wiper/brake wiper
Have you checked the throttle pot & brake switches? Yes, the controller will shut it down if it fails any of the self tests. That's what they are for. Just imagine the cart going full acceleration/ no brakes as soon as you turned it on?!
|
Re: 2013 Ezgo Rxv handle code help! Throttle wiper/brake wiper
Here's the discribtion of the self test:
Understanding the Power-up Sequence The car will perform the following checks during the first second of initial key - on. Electric brake check Controller tries to rotate the motor Ό turn in both directions. Reverse alarm check Controller sounds the alarm for 100ms. Charger inhibit check Controller checks the charge receptacle for connection to the charger. Throttle switch check Throttle switch must be open to pass the start up test. Throttle position sensor Controller checks the TPS for 0% throttle. Throttle operation check Controller checks the TPS for the correct open and closed range. The car will not run if the controller detects a problem with any of the circuits above. |
Re: 2013 Ezgo Rxv handle code help! Throttle wiper/brake wiper
1 Attachment(s)
Quote:
|
Re: 2013 Ezgo Rxv handle code help! Throttle wiper/brake wiper
90% of the time it's lying about what's wrong. Oftentimes a bad speed sensor in the motor (also part of the 5V bus) can trip one of these codes. I spent months on a few trying to figure that one out!
|
Re: 2013 Ezgo Rxv handle code help! Throttle wiper/brake wiper
Tested the volts going to brake sensor and I am not getting 5 volts.
|
Re: 2013 Ezgo Rxv handle code help! Throttle wiper/brake wiper
Sounds like you have a bad controller. Do you have another controller you can put in the cart to see?
|
Re: 2013 Ezgo Rxv handle code help! Throttle wiper/brake wiper
I changed the controller with one I bought from a guy that he said was good and still the same thing
|
Re: 2013 Ezgo Rxv handle code help! Throttle wiper/brake wiper
See if you got 5v on pin 15. That sends the voltage to the brake and throttle sensors.
|
Re: 2013 Ezgo Rxv handle code help! Throttle wiper/brake wiper
I am getting 4.96 volts on wire 15
|
All times are GMT -5. The time now is 02:07 PM. |
Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
This Website and forum is the property of Buggiesgonewild.com. No material may be taken or duplicated in part or full without prior written consent of the owners of buggiesgonewild.com. © 2006-2017 Buggiesgonewild.com. All rights reserved.