G1 engine hone
I need to buy a honer for my cylinder, i bought one from autozone but it wasnt the right stones returned it so i found one with 2 inch stones on it and it says for size 32-89 mm, and the stones are 2 inch and 51mm, im not good at mm sizes should this size work ok and 2 inch stones? Thanks.
|
Re: G1 engine hone
Should be good to go, just watch the ends at the ports as you hone.
|
All times are GMT -5. The time now is 08:29 AM. |
Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
This Website and forum is the property of Buggiesgonewild.com. No material may be taken or duplicated in part or full without prior written consent of the owners of buggiesgonewild.com. © 2006-2017 Buggiesgonewild.com. All rights reserved.