|
ITS Throttle Sensor Testing
Is there a way to test an ITS Throttle sensor? Should it have continuity? The test I have run suggest that it is bad but I tried one I had on the shelf and It did not help. It could be bad also but I would like to test them before I buy another one. Any ideas will be greatly appreciated.
Tommy |
Re: ITS Throttle Sensor Testing
2 Attachment(s)
There are a couple guys trying to come up with a bench test for an ITS sensor, but there is more to an ITS throttle than just the sensor.
There are three parts to the system and two of the three parts are within the controller. 1. Power Source. (Controller) 2. Current/Voltage measuring circuit. (Controller) 3. Proximity detector. (ITS sensor and plunger) Since the Controller provides the power and measures the results, the best way to test an ITS sensor is with it connected to the controller it is going to be used with and see if it produces the voltages as specified for that specific controller. The same sensor is used with different controllers and have different voltage measurements. |
| All times are GMT -5. The time now is 09:13 AM. |
Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
This Website and forum is the property of Buggiesgonewild.com. No material may be taken or duplicated in part or full without prior written consent of the owners of buggiesgonewild.com. © 2006-2017 Buggiesgonewild.com. All rights reserved.