Pre charge resistor burned
48 volt cc 4 batt. Noticed the pre charged resistor melted until I unhooked battery.any ideas? Also there is a red wire lead from battery 1 and blue wire lead from batt 4 where do these wires go?thanks
|
Re: Pre charge resistor burned
Solenoid failure is often a cause of this.
|
Re: Pre charge resistor burned
When the solenoid fails to energize, the controller will attempt to power the motor through the pre-charge resistor. Likely this is what happened. Either the solenoid failed when asked to energize OR the solenoid activation circuit failed.
So 2 possibilities, solenoid failure or solenoid activation failure |
All times are GMT -5. The time now is 11:35 PM. |
Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
This Website and forum is the property of Buggiesgonewild.com. No material may be taken or duplicated in part or full without prior written consent of the owners of buggiesgonewild.com. © 2006-2017 Buggiesgonewild.com. All rights reserved.