Still not working
 

I thought I had someone lined to look at cart, but he's too busy along with a few other mechanics I called--- the cart works in reverse, but not forward-- is there anything besides the (rocker) switch I should be looking at. Thanks for any recommendations.

Re: Still not working
 

I forgot to mention it is an 07 EZGO PDS 36v

Re: Still not working
 

If the switch checks ok, that usually means one side out the controller has failed. Switch the f1 and f2 wires at the controller and see if the problem reverses. If it does your controller is bad.

Sent from my SM-G930R4 using Tapatalk

Re: Still not working
 

Thank you I'll try that this afternoon

Re: Still not working
 

I just reversed the cables , now it only goes forward--- so much for the brand new controller--- will it hurt to leave it wired the way it is and use the cart until I get a new controller?--- thanks again for the help

Re: Still not working
 

It will not hurt to run it that way. If its new what kind of controller is it? Should have some warranty on it?

Sent from my SM-G930R4 using Tapatalk

Re: Still not working
 

I'm going to contact them --- it's a Curtis 1206 mx

Re: Still not working
 

Was it new, or rebuilt? If I had to guess I bet it was a rebuilt one. Even so it should have a one year warranty. Get your money back and get you an Alltrax XCT.Sent from my SM-G930R4 using Tapatalk

Re: Still not working
 

It was brand new --- I'll look into the Alltrax-- thanks again for your help

Re: Still not working
 

Still having problems, I installed a new controller (haven't got the Alltrax yet) , but got a deal on a rebuilt Curtis, so I changed it, and it's doing the same thing--- reverse but no forward, switched the 2 wires in controller and it runs in forward but no reverse, the only part I haven't changed is the reverse buzzer, would that cause the problem ???---/ thanks