89 PG3 What should compression be
I have a 1989 EZGO. that will not start!
I believe it is a PG3 engine? Compression tested to 120 psi. Ran leak down test and was seeing gas coming out of the crank seal. Reed valves look good. I have already went through the carb. Am I on the right track????? Is a 120 psi compression enough for these type motors? Can anyone help a new guy out??? Thanks, Pete |
Re: 89 PG3 What should compression be
Compression is low. Should be 140 or more.
|
Re: 89 PG3 What should compression be
mike,
when i took this reading the motor was cold. are your numbers warm or cold |
Re: 89 PG3 What should compression be
Doesn't really matter - 120 is low (not terrible - but low). Do you have a "warm" reading?
|
All times are GMT -5. The time now is 10:33 PM. |
Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
This Website and forum is the property of Buggiesgonewild.com. No material may be taken or duplicated in part or full without prior written consent of the owners of buggiesgonewild.com. © 2006-2017 Buggiesgonewild.com. All rights reserved.