torque kit
good morning! i have a question about the sticky" torque kit install" when you take off the c-clip and put on the spacer. what keeps the spacer from sliding down the shaft and hitting ?thanks k.g
|
Re: torque kit
The spacer has a somewhat of a small lip that will catch on the groove that the c-clip was attached.
|
Re: torque kit
that makes sense !thanks for your help...
|
Re: torque kit
Your welcome. The torque kit (in my opinion) is the best and cheapest mod you can do to a lifted Yamaha with oversize tires. :thumbup:
|
Re: torque kit
Quote:
|
Re: torque kit
i installed the torque kit once on my g-1 and i didn`t like it .but i did not take off the c-clip .so i was going to try it again ;but the g-1 allready is fast and pulls good but my g-9 limo is slow and doesn`t pull good does anyone know if it will fit the g-9?? and what legth belt may help the g-9 ??
|
Re: torque kit
The torque kit should be the same. You definitely need to remove the c-clip. If your looking for a smaller belt for the G9, you can try one from a G1 it is a little shorter:
G1 = 1-3/16" x 36-3/8" G9 = 1-3/16" x 39" |
Re: torque kit
from what ive read about other carts a 1" shorter belt will work.
Ive had a hard time finding a shorter belt for a G9 of a neighbors. After digging around, I have found that a belt for a Columbia/HD cart 61-66 should work. the OEM # is 36394-61. i did some searches and found that belt to cost between $90-130 i also found it on a site called www.dealsinapinch.com for 31.89 plus shipping ($11 to utah) the length is 1-3/16"X38.2." which is the closest i could find... if i ever get more time and $$ ill try it out. unless someone else wants a crack at it first. |
Re: torque kit
Ive been doing alot of searching on this Belt length subject with yamaha's. Havent been able to find much. although i did find today that a columbia/HD (OEM # 36394-61) belt may work from '61-'66. but they are about $82-$130.
I did do a search on a belt of the same dims (1-3/16"X38.2") minus appx one inch, and found one at a place called www.dealsinapinch.com for $31.89 (P/N A-1930V375)plus shipping about $11 to me. i have found some belts out there that are 38.8" long, but dont think that would be short enough to make a difference. now if i can ever get to it, i think it may work. |
Re: torque kit
sorry, double, now triple post :)
|
All times are GMT -5. The time now is 07:14 AM. |
Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
This Website and forum is the property of Buggiesgonewild.com. No material may be taken or duplicated in part or full without prior written consent of the owners of buggiesgonewild.com. © 2006-2017 Buggiesgonewild.com. All rights reserved.