Rev limiter 98 CC (or lack thereof)
I was just reading a post by Joe1992 who was searching for his RPM limiter without success and guess what ? I have the same issue with a 98 CC. I installed a tach for a friend and did the usual tricks re the rod length, governor etc but the limiter is kicking in at around 2500 RPM's. I went to remove the limiter ground wire and,,,,,,,,,,,,,,,,,,,,,, there is no limiter where it normally resides (bolted to the front engine casing).
I didn't have time to track it down yesterday since he was needing to play a competition but my question is; did they relocate the limiters on some models and if so, for what reason ? Your wisdom will be much appreciated as always. :thumbup: Chris. |
Re: Rev limiter 98 CC (or lack thereof)
good question.did you feel for holes that might be there its possible the limitor was taken off?????? as far as i know they didn,t put them anywhere else..........................in late 96 they did away with the ignitor behind the limitor and incorperated it into the coil but the limitor was still in the same place.............................8)
|
Re: Rev limiter 98 CC (or lack thereof)
Quote:
Chris. |
All times are GMT -5. The time now is 09:32 PM. |
Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
This Website and forum is the property of Buggiesgonewild.com. No material may be taken or duplicated in part or full without prior written consent of the owners of buggiesgonewild.com. © 2006-2017 Buggiesgonewild.com. All rights reserved.