RXV Motor Brake Replacement Proceure
 

I know I've seen in a thread on here a step by step procedure for replacing the brake on an RXV. I've searched and came up empty. Anyone seen it by chance?

Re: RXV Motor Brake Replacement Proceure
 

I have this from cgtech:

RXV brake replacement



Thanks Pinball, hope the new brake arrives today. These are the directions I'm following:

1) DO NOT over tighten bolts
2) CLEAN MOUNTING SURFACES and motor lug
3) Do not unplug or plug brake connector with key on or in "N" ( Key off while PLUG'n)
4) Brake should be ENERGIZED (cart in tow mode - key to "N" ) while brake bolts tightened.

Put the cart on flat ground, chock wheels (both of these are very important). Tow position, key off, leave batteries hooked up ( you will need power during re-install.) Unplug the brake, remove 3x 10mm bolts on brake. Remove brake. Clean mounting surface on motor. Hang new brake on armature, push cart just slightly to point plug towards top to line up holes. Start all three bolts (just barely). Plug brake in, put cart in neutral (this should unlock the brake, don't let the cart roll away).
Tighten bolts evenly to 10 n-13 INCH POUNDS, if you don't have a inch-torque wrench, tighten the bolts enough to fully compress the lock washers, not much more.. Turn key off, tow/run back to run, turn key on, test drive, celebrate with beer


cgtech

If the holes aren't aligned on the new brake, I have a proceedure for that also. I will post if necessary. I have not actually done this myself but I watched it once on a cart with a back seat. The seat didn't have to be removed in this case.

Re: RXV Motor Brake Replacement Proceure
 

Thanks!!!

Re: RXV Motor Brake Replacement Proceure
 

Also, the three long machine screws the hold the motor brake to the motor seem to corrode a lot. Dissimilar metals or something. You may need to dress the threads on a wire wheel before reinstalling. I also add some anti-seize to those screws for protection.

Re: RXV Motor Brake Replacement Proceure
 

will do. appreciate the help!

Re: RXV Motor Brake Replacement Proceure
 

I unlock the brake with the tow switch before I try to insert the three bolts. It makes it a lot easier to line everything up and get them started. Then tighten them to the minimum torque with the brake unlocked.

Re: RXV Motor Brake Replacement Proceure
 

Procedure should be in stickies.....

Can this be done?????

Re: RXV Motor Brake Replacement Proceure
 

I got it done, but for some reason the only way I could unlock the brake in order to get all of the bolts in was to use the plugs under the run tow switch. After finally doing that, it was a piece of cake.

Re: RXV Motor Brake Replacement Proceure
 

Can I have that procedure for the bolt holes not aligning?

Re: RXV Motor Brake Replacement Proceure
 

Here you go cgtech posted this at one time or another.