Help wiring starter generator
I have bought a Club Car that has a FE400 engine. It has the old style CW generator, The previous owner stripped 100% of the micro switches and wiring. I have the cart re-wired (less Micros) with a key start switch and everything works except I cannot get the generator to charge the battery. If I run a jumper from the +12 on the regulator to the battery, the charging works perfect.
The local dealer say's that the starter solenoid should stay engaged with the gas pedal pressed but I'm concerned about keeping that solenoid switch engaged for that long. It looks like an old Ford solenoid and they would not stand being engaged for long periods. My local dealer wants me to replace the entire factory harness but this seems silly when I'm so close to having it working. I have the wiring schematic and it shows a diode on the solenoid. Could this be the issue? I can't believe that I'm the first guy that has a cart that has the whole factory harness removed. Any help out there? |
Re: Help wiring starter generator
I should have said that it has an old style generator but is running CW for the FE400
|
Re: Help wiring starter generator
The ford style automotive solenoid will not last long. And yes, it stays energized at all times while the pedal is pushed and needs the diode. Cart system does not work the same as a automotive starting circuit.
As long as you are following the diagram with your harness then keep going and save your money. You can get micros off the net or ebay but I've found that checking the dealer first sometimes pays off. I am picking up an ignition coil for a FE290 from the dealer for $43.00 and the cheapest place on the net was $54.00 plus shipping and who knows what third world country made it. Just a thought. |
Re: Help wiring starter generator
I see the diode in the schematic but I don't have the additional wires hooking o the solenoid so I'm not sure what the diode does.
My wiring is pretty simple. Hot wire to ign switch Hot wire to relay that opens the white/black for shutting down engine Start wire to solenoid Lights Oil level switch Generator wiring is still original. What I need to do is in install a micro on the gas pedal to engage the solenoid and provide 12v to close solenoid. Where does the diode go and what is it's purpose? |
Re: Help wiring starter generator
have you checked the voltage regulator for your charging problem?.........................................8 )
|
Re: Help wiring starter generator
I have solved the problem. The new regulator was turned up to 20+ volts. When I adjusted it, the charging system started working. Also, someone installed an automotive style solenoid so I have changed it to the factory Club Car.
Everything seems to be good. |
Re: Help wiring starter generator
Welcome to the forum hdpickup..................
|
All times are GMT -5. The time now is 07:00 AM. |
Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
This Website and forum is the property of Buggiesgonewild.com. No material may be taken or duplicated in part or full without prior written consent of the owners of buggiesgonewild.com. © 2006-2017 Buggiesgonewild.com. All rights reserved.