Need Help 1987 Ezgo resistor cart 36V won't run
 

Can't get cart to run (was running fine) with 4 ga wires all tight
I checked F&R switch and micro switches and speed control micro with parts from a cart that works
even pulled the motor to bench test it, it works fine
I didn't check solenoid cause my brother said it tested fine
when I put the meter on the big posts of solenoid it reads 16v when I check the working cart it shows around 38v ???? why the differnce
1) have I missed something
2) don't trust my brother
3) is the solenoid my problem

Thank you in advance
Matt

Re: Need Help 1987 Ezgo resistor cart 36V won't run
 

Sounds like the batteries are cabled up wrong? What is the voltage reading accross the pack ?

Re: Need Help 1987 Ezgo resistor cart 36V won't run
 

around 38v wish cart was here to give accurate numbers all batteries check out around 6.7 5 month old carts been working like a champ but other people use it
http://i183.photobucket.com/albums/x...r/IMG_0047.jpg

Re: Need Help 1987 Ezgo resistor cart 36V won't run
 

I was online looking for parts to my cart and noticed your problem posted. Mine did exactly the same thing.
It has a controller that goes from the accellerator that ends with a brass control that gets corroded and sometime you just have to remove it and shine it up. It works similiarly to a brush on a motor.

Mine was not going at all and I have found that when it gets dirty, you can sometime "STOMP'' on the accellerator and it gets a charge through it. It still needs to be cleaned but it will run fine for awhile.

I also found that you could get it rolling downhill (the first thing I tried) and hit the accellerator and it started going. No more problems until the following day. That's when I found the controller with burn spots on it.
Now, after you try this, I will check back on the board and see if you had any luck.

Stomp it good and hard, now.:lol:

Re: Need Help 1987 Ezgo resistor cart 36V won't run
 

OH, I almost forgot. Make sure the key is on and that you don't run into anything.

Re: Need Help 1987 Ezgo resistor cart 36V won't run
 

87 is a resistor cart have you tried jumping the large post on the solenoid? if not jack rear up put cart in gear jump large post on solenoid turn key on hit gas if cart runs replace solenoid................................8)

Re: Need Help 1987 Ezgo resistor cart 36V won't run
 

Thanks will be where the cart is for the opening of duck season on Friday
can't wait to try all the suggestions

Re: Need Help 1987 Ezgo resistor cart 36V won't run
 

Heard about that one today also will post results when I get back
Thanks

Re: Need Help 1987 Ezgo resistor cart 36V won't run
 

Problem turned out to be a bad connection, where cable is crimped at the lug hidden under the shrink wrap that is there to protect them. found two bad cables.
Cart runs fine Thanks again for all your help

Re: Need Help 1987 Ezgo resistor cart 36V won't run
 

hi i got a 87 ez go to where can i find a high torque motor for it or any kind of parts like the way u have yours