Buggies Gone Wild Golf Cart Forum
Page 1 of 3 1 23 >
Show 40 post(s) from this thread on one page

Buggies Gone Wild Golf Cart Forum (https://www.buggiesgonewild.com/index.php)
-   Electric EZGO (https://www.buggiesgonewild.com/forumdisplay.php?f=16)
-   -   98 ezgo WIDE OPEN ONLY (https://www.buggiesgonewild.com/showthread.php?t=75389)

BACKWOODS 01-27-2013 12:29 PM
98 ezgo WIDE OPEN ONLY
 
1998 EZGO DCS WITH 500 ALLTRAX CONTROLLER.
Forward only has 1 speed wide open.If you give it 1/2 throttle it bucks back and forth surging like it has bad connection.Push it to the floor and everything is fine.What could it be?

Gonkulor 01-28-2013 10:13 AM
Re: 98 ezgo WIDE OPEN ONLY
 
Quote:
Originally Posted by BACKWOODS (Post 831645)
1998 EZGO DCS WITH 500 ALLTRAX CONTROLLER.
Forward only has 1 speed wide open.If you give it 1/2 throttle it bucks back and forth surging like it has bad connection.Push it to the floor and everything is fine.What could it be?
You said, bad connection. That might be the place to start. Double and triple check all your connections. Unplug, and plug everything back in. Make sure everything is tight. You might have troubles in a few areas. make sure your at full pack power.

Have you done anything recently to your cart? Washed it? Added something?

scottyb 01-28-2013 10:33 AM
Re: 98 ezgo WIDE OPEN ONLY
 
Welcome to beat BGW

I experience this once, I had put a controller with the wrong throttle input into the cart. Check to see if the throttle input in your Alltrax controller is set for Ezgo ITS.

BACKWOODS 01-28-2013 04:54 PM
Re: 98 ezgo WIDE OPEN ONLY
 
Nothing has changed in 2 years.Hunting buggy been using every weekend since Deer season opened in October.Cart was fully charged when I left for hunt and ran perfect.When I returned after hunt is when it acted up.Never drove thru any puddles either.All battery connections tight and no corrosion.Connections to controller are hard wired so no loose plugs to worry about there.Thanks for replies and anymore suggestions to check.1st post here but have been lurking here for years getting info on selonoids and such has been helpfull.

gornoman 01-28-2013 05:02 PM
Re: 98 ezgo WIDE OPEN ONLY
 
Speaking of solenoids....

pggroves 01-28-2013 10:27 PM
Re: 98 ezgo WIDE OPEN ONLY
 
If I were troubleshooting I'd crack open the pedal box and at least check the ITS... :dontknow:

BACKWOODS 01-28-2013 11:37 PM
Re: 98 ezgo WIDE OPEN ONLY
 
Quote:
Originally Posted by pggroves (Post 832292)
If I were troubleshooting I'd crack open the pedal box and at least check the ITS... :dontknow:
That is what I was thinking.Any how too's on checking that ?

scottyb 01-28-2013 11:59 PM
Re: 98 ezgo WIDE OPEN ONLY
 
You can check the throttle out put at the controller. That's easier than going into the box. The output range differs from manufacture to manufacture. What controller do you have?

BACKWOODS 01-29-2013 12:03 AM
Re: 98 ezgo WIDE OPEN ONLY
 
Quote:
Originally Posted by scottyb (Post 832332)
you can check the throttle out put at the controller. That's easier than going into the box. The output range differs from manufacture to manufacture. What controller do you have?
alltrax 500

scottyb 01-29-2013 01:32 AM
Re: 98 ezgo WIDE OPEN ONLY
 
Alltrax ITS throttle signal test:

Test pin #2 to Pin #3
Peddle up reading should be 10v down should be 6v
12v = bad ITS 14v = Open circuit


All times are GMT -5. The time now is 09:20 PM.
Page 1 of 3 1 23 >
Show 40 post(s) from this thread on one page

Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
This Website and forum is the property of Buggiesgonewild.com. No material may be taken or duplicated in part or full without prior written consent of the owners of buggiesgonewild.com. © 2006-2017 Buggiesgonewild.com. All rights reserved.