New solenoid/ No click
 

I put a new solenoid on my 96 EXGO DCS. When i press the excelerater nothing happens. The cart is fully charger. I am pretty sure the controller is shot but would like some other opinion.

Re: New solenoid/ No click
 

mine was doing this same thing, and turned out mine was the micro switch right beside the solenoid.. hard to say but this is from my experience, and you are in a great place here, they can help with almost anything!!! good luck

Re: New solenoid/ No click
 

you can do a continuity test on the micro to check it with a voltmeter

Re: New solenoid/ No click
 

Why the new solenoid?

Did you switch the controller toggle switch to TOW before starting the work?

Did you switch it back?

Re: New solenoid/ No click
 

The reason for the new solenoid is basically stupidity on my part tring a test that was the wrong test for that motor. Smoke from the controlller and solenoid . I knew then i had screwed up. I was told the controller was bad when i got it so there was no loss there. the cart shop in the nearest town is getting me a new controller. More to come with pics soon.

Re: New solenoid/ No click
 

Crosswired what kind of controller are you getting?

Re: New solenoid/ No click
 

Alltrex 300amp for a dcs.He is going to get a rebuilt. (I hope)

Re: New solenoid/ No click
 

If you plan on a lift in the future or have one I would upgrage to a 400 since you already have to spend the money and it is programable also.

Re: New solenoid/ No click
 

So I have the same problem where is the micro switch located?

Re: New solenoid/ No click
 

Welcome beckster, we prefer a new thread for each question......helps us keep all of this semi-staight.... Click new post instead of reply!