Re: Powerwise II Parts?
I can’t see what you have the meter set on but if you followed the instructions in the video then I’m thinking it’s bad. They’re cheaper than a board so might not hurt to give it a try.
|
Re: Powerwise II Parts?
In a Powerwise 2 the relay is mounted on a small circuit board and is a relatively cheap and easy replacement. But if the "timer" board that it screws to goes bad the price of that can make you swallow your bubblegum.
|
Re: Powerwise II Parts?
Take your capacitance meter to a place that sells capacitors and test one of them. A typical capacitor range would be around 8 Mfd 600 volts AC. Take your suspect capacitor with you and compare reading with known good capacitor.
|
Re: Powerwise II Parts?
Quote:
|
Re: Powerwise II Parts?
Did you listen for the relay in the charger to click when you plug charger into cart? This relay is powered by the cart battery voltage. I hear mine click a few seconds after I plug it into cart. This relay completes the AC path to the transformer. No click no hum.
|
Re: Powerwise II Parts?
Quote:
|
Re: Powerwise II Parts?
1 Attachment(s)
I completely agree.. That said you can test the cap all day long but if the transformer doesn’t power up you are wasting your time..
If you end up needing a cap attached is a pic of one that will work.. |
Re: Powerwise II Parts?
To TxMasterBoat,
Capacitor may not be the problem but it would be a good test to get familiar with your meter. The video you watched shows how simple it is. You don't have to know what the value of the capacitor is to measure it. If you are going to fix this thing you need to review what others have suggested. Typical capacitors in these type of chargers are in the range of 8 to 20 Microfarads. Post a pix of your meter so those of us are trying to help you select the right settings on you meter to make some measurements of why the transformer don't hum when you plug it in without you having to plug it in to AC. I am not real familiar with this charger. I had the opportunity to repair only one (mine). It had low current output and proved to be a weak capacitor. |
Re: Powerwise II Parts?
My Powerwise Industrial charger (Model 28115G01) has developed a problem. It has been working about 7 years with no problem. I know the charger is bad because I have another more modern Powerwise 2 works. I got a chance to review some of the advice I have offered on this post. My charger suddenly developed low output current and a more than normal hum when it turns on. First thing I checked was the capacitor. It was badly corroded and rusted but it measured 19.8 Microfarads. A substitute capacitor did not change anything. Both diodes checked good. The only abnormal indication was the secondary of the transformer got warm after a few minutes of operation. Neither diode was more than warm to the touch. This charger also has a circuit board mounted in front of the diode heat sink may be the problem. My GUESS is the transformer is bad. I am not going to replace it. I did make one observation with the capacitor disconnected. The charger would not hum when powered up and plugged into cart.
|
Re: Powerwise II Parts?
1 Attachment(s)
Went and found an old thread with the charger manual and diagnostics. With the capacitor connected the transformer should be putting out high 80s to low 90s AC. If not it is bad.
|
All times are GMT -5. The time now is 05:56 PM. |
Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
This Website and forum is the property of Buggiesgonewild.com. No material may be taken or duplicated in part or full without prior written consent of the owners of buggiesgonewild.com. © 2006-2017 Buggiesgonewild.com. All rights reserved.