Yamaha G2-G9 not starting after.....
 

Hey guys I posted earlier this morning about my muffler studs broke and how to remove them ect...well I got it fixed and looks great only thing is that I did not have a gasket to install just yet, so my question would be would that gasket stop the motor from going ??? Because know all it’s doing is acting like I it’s getting to much fuel/poping here and there curious if it’s getting air from not having that gasket and throwing off the air flow to make it run

Re: Yamaha G2-G9 not starting after.....
 

Nope, should still run and be very loud.

Re: Yamaha G2-G9 not starting after.....
 

I was looking at it closer and there is one red wire on the that black box had corroded off would that be a problem ? I can’t figure it out this cart always started perfect

Re: Yamaha G2-G9 not starting after.....
 

picture?
Black box?

Re: Yamaha G2-G9 not starting after.....
 

Sorry it’s the igniter and I’ll post pics tomorrow have to figure out how to fix it ?

Re: Yamaha G2-G9 not starting after.....
 

You can remove the terminal out of the connector, solder the wire back to the terminal and then put it back into the connector. Probably your best bet

Re: Yamaha G2-G9 not starting after.....
 

Yea to bad they don’t make a connector to have them all replaced

Re: Yamaha G2-G9 not starting after.....
 

[IMG]http://i1300.photobucket.com/albums/...stztq7ut5.jpeg[/IMG]

Re: Yamaha G2-G9 not starting after.....
 

Re: Yamaha G2-G9 not starting after.....
 

Dont think I'd even bother with that. After seeing how well the Chrysler setup works I think I'd just go that route and sell the ignitor on Ebay or save it for a rainy day