99 ez go weak spark
txt,295cc new carb,all electric parts,problem is 1-plug gas fouled other plug
is carbon fould,tried other plugs same as before |
Re: 99 ez go weak spark
Are both cylinders firing?
|
Re: 99 ez go weak spark
only one is firing
|
Re: 99 ez go weak spark
Quote:
|
Re: 99 ez go weak spark
Quote:
|
Re: 99 ez go weak spark
all new electrical parts,coil ignition, pulsercoil ,volatge reg. ,ignitor ,solenoid, got the parts from ezgo.
|
Re: 99 ez go weak spark
Aye Carumba!!! Well that about covers all the ignition!! Let's try this... A new part does not always guarantee a good part, and we know we only have fire on one cylinder. We'll put the lean condition on the back burner til' we figure out the firing. Start with the plug wire itself. Remove the plug and insert in into the wire. Ground out the electrode on the plug and mash the accelerator ( with cart in neut. or on jacks ) and see if you see any fire. If not, remove the wire from the coil, trim the end, and inspect the inside to look for defects. If all is good reinstall the wire and check the plug end well and repeat the process of grounding out the plug.... I have never seen one side of the coil go bad, but I guess it is possible... Hope this helps ya...
|
Re: 99 ez go weak spark
:shock::shock:will try plug wires...off to work we go
|
Re: 99 ez go weak spark
found one plug wire, not working fixed wire.......now motor only runs with air filter
removed........ |
Re: 99 ez go weak spark
So now we do have both cylinders firing properly, correct?
|
All times are GMT -5. The time now is 06:49 AM. |
Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
This Website and forum is the property of Buggiesgonewild.com. No material may be taken or duplicated in part or full without prior written consent of the owners of buggiesgonewild.com. © 2006-2017 Buggiesgonewild.com. All rights reserved.