Gas cc will not do anything until i jumpier across solenoid
Sat for about three years. Got it home. Got it running. Ran fine for about an hour. Went to go drive it for the first time, went two feet and stoped. Now cant get it to do anything unless i jumpier across the solenoid, and that just turn the motor over. The micro switch's all click. Replaced the solenoid with one from a auto parts house( which i was told would not work ). I dont know
|
Re: Gas cc will not do anything until i jumpier across solenoid
You can use a voltmeter or test light to diagnose the solenoid activation circuit or just replace it with the OEM solenoid.
|
Re: Gas cc will not do anything until i jumpier across solenoid
just because the micros click dosent mean they are working! just like a rifle, you can get a bang with no kick! this means the bullet will get hit by the firing pin, but the bullet will not exit the casing! get a volt meter and set it to a contunity or diode test or a beep test. test with one lead one each connector. red on one, black on one. squeeze each micro. if it does the oppitite of when yo started, beep, or no beep its can be assumed a good switch. if it stays the same, assume bad switch.
all the soloiud is a heavy duty switch. that has to be energised to work. if its not receiveing the signal it will do whta is told...nothing! like it was brought up in your previous post. |
Re: Gas cc will not do anything until i jumpier across solenoid
okay i replaced all the micro switch and still nothing. turn the starter by hand and still nothing.
|
Re: Gas cc will not do anything until i jumpier across solenoid
ALL the micro-switches? What about the 2 in the black box?
|
Re: Gas cc will not do anything until i jumpier across solenoid
yes all four of them. i dont know were to go now
|
Re: Gas cc will not do anything until i jumpier across solenoid
well just got it running. replaced all 4 micro switch's, replaced some wire terminals, PUT THE ORIGINAL SOLENOID BACK ON. It fired right off. So i think it was the switch's
|
Re: Gas cc will not do anything until i jumpier across solenoid
Quote:
|
Re: Gas cc will not do anything until i jumpier across solenoid
Quote:
was getting to many different answers on it, so i tried it. i look at it has i took one for the team.. |
Re: Gas cc will not do anything until i jumpier across solenoid
Glad you got it running :thumbup:
But you lost me on this, was getting to many different answers on it ? the only thing I see talked about in this thread is the switches and the solenoid, and you say the switches were the problem :thumbup: :lol: Quote:
|
All times are GMT -5. The time now is 12:05 PM. |
Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
This Website and forum is the property of Buggiesgonewild.com. No material may be taken or duplicated in part or full without prior written consent of the owners of buggiesgonewild.com. © 2006-2017 Buggiesgonewild.com. All rights reserved.