03 No spark
 

I am working on an 03 Ez with no spark. I have checked all the wiring several times, no corroded terminals, no broken wires or anything. I replaced the pulsar coil because it didn't seem to check out right don't remember what it was but according to the manual it was bad. Everything I read says to gap it about the thickness of a business card, mine has no adjustment on it. Any way no spark. I replaced the igniter today tried it with a spark plug against the exhaust sparked 1 time then nothing. I am at a loss at what to do next. Any help would be greatly appreciated. Ignition coil? Thanks Earl

Re: 03 No spark
 

Let us trace your wiring connection from the igniter side. There are 5 wires coming out of the igniter. Two of them are connected to the pulsar. One (middle) is a ground wire and should be properly grounded (connect to one of the small solenoid terminals). The last two are wired like this: one goes to one of the small solenoid terminals- the opposite of the small ground wire. The other one goes to the ignition coil.

Re: 03 No spark
 

Here is what I have, I have the 4 wires in the plug white,red/white,red,black then I have a black/white wire with a female connector is hooked to the top bolt that holds the igniter on,it has a black wire from the reverse alarm hooked to it also. I have a red wire from the plug on the D lug on the solenoid (according to the diagram of the wiring diagram],also have an orange/white wire on the same lug. The blue wire from the ignition switch is hooked to it also. I have no ground going to the solenoid it is grounded on the igniter bolt.
I have added some pictures maybe that will help.
Thanks Earl

Re: 03 No spark
 

Anybody have any ideas?