Clone throttle linkage help!
 

Ok guys...What was your solution for the throttle set-up? 16hp Carroll Stream engine, 1990 CC I had to remove the black box for clearance. The throttle rod is right in line with the air box and doesn't allow for the bell crank to be used. Did you remove the airbox completely and run an aftermarket air cleaner?

Re: Clone throttle linkage help!
 

Pics of what I did in a 1991 Carry All but, somebody else made it look easier ... they may chime in or you may have to search and find it? Good Luck :thumbup:

Re: Clone throttle linkage help!
 

searching now... were you able to put the stock air cleaner back on??

Re: Clone throttle linkage help!
 

Here's how I did it...works well and bypasses the gov. You could put the stock air box back on but I didnt have enough clearance so I made a snorkel and relocated the intake to the bagwell.

http://sphotos.ak.fbcdn.net/hphotos-..._8173842_n.jpg

http://sphotos.ak.fbcdn.net/hphotos-..._3389703_n.jpg

Re: Clone throttle linkage help!
 

LOL Extreme! That's an Ezgo ... motor sits in a CC reversed ... Yes I was able to put the stock Air cleaner on. But somebody did it better ..... Besides Extreme ...... in a CC :mrgreen:

Re: Clone throttle linkage help!
 

i pretty much did what scotty b did. his looks a little better though so i won't post a pic. due to modesty. and i also ditched the black box because it didn't have anything in it that i needed. working out stock air cleaner, and exaust. pretty sure i can make them work too. everything has just been put on hold with the cart due project overloads. expect to get back to it soon.

Re: Clone throttle linkage help!
 

Here's what I have so far...I need to make the connection to the engine. Please ignore the booger welds!

are you guys running the governor???

Re: Clone throttle linkage help!
 

With the linkage mounted to the frame, does your throttle ever act up as the suspension articulates or when the cart goes over bumps?
I put a throttle cable on my CC with a clone swap but this looks easier.



What did you all come up with for the choke cable hook up?

Re: Clone throttle linkage help!
 

Good observation. Yes, if you have a lot of suspension travel or ride in very rough terrain that set up will tug on the throttle a little bit. But not much as the carb is at the end of the swing arm that moves very little.... So Not as good as an engine mounted cable. The CC has a solid linkage and it is not easy to transition to a cable from there :help:

Re: Clone throttle linkage help!
 

jblack do you want to sell the black box you took off mine has grown legs and walked off !!!!