Re: axle bearing and seal replacement.
what about the new seal...? is that installed with the 3/4" pipe as well.?? is there a stop..?
new to this and trying to change my moms ezgo bearing and seals later this evening.. thanks |
Re: axle bearing and seal replacement.
Quote:
|
Re: axle bearing and seal replacement.
Love ohms law that was on all my electrician test a school before I got my electricians license my high school treacher That couldn't teach me algebra but my ele.teacher had no problem
|
Re: axle bearing and seal replacement.
Ive been trying to find the part numbers I need for my 94 electric marathon, I have the 611931 , but i need the input shaft bearings, intermediate shaft bearings and carrier bearings as well as the two freeze plugs? am I looking in the wrong place? Id like to order them but having a hard time finding the part numbers.
|
Re: axle bearing and seal replacement.
Hey guys, New member here!... Well, I have been lurking for a while. I finally signed up today!
Just wanted to say thanks, all the info above makes sense and I recently replaced the input shaft on our electric 1990-1991 Marathon cart & the motor coupler as well... Both were completely stripped. Done the fronts already but the rear wheel bearings are really noisy... The 1990 model should be the same as you guys are talking about above, right?... As in the rear axle removal only needs the drum and the first locking "bearing" clip removed and then the axle can be pulled out, correct? Then the next locking clip, then the seal... Just want to make sure there is not any difference and I cant seem to find a Repair Manual anywhere for it. I did find the Parts Manual though and that helped tons! The shop tried to charge us like $1,800 for a new electric motor and a new rearend where I repaired it myself for like $50-$60... Thanks to the info found with you guys! Thanks again, Kelly |
Re: axle bearing and seal replacement.
Should be the common Dana axle with a steel pan on the bottom. If so, then yes, easy.
|
Re: axle bearing and seal replacement.
What about the front hub bearing is there a auto equivalent?
|
Re: axle bearing and seal replacement.
Quote:
|
Re: axle bearing and seal replacement.
So will the bearings sit flush with the end of the axle tube? Just passed the c clip spot?
|
Re: axle bearing and seal replacement.
2 Attachment(s)
Quote:
|
All times are GMT -5. The time now is 08:42 AM. |
Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
This Website and forum is the property of Buggiesgonewild.com. No material may be taken or duplicated in part or full without prior written consent of the owners of buggiesgonewild.com. © 2006-2017 Buggiesgonewild.com. All rights reserved.