Clutch Removal Bolt Tool - KF82
Just a quick question, has anyone ever used the '88 and up clutch removal tool (the bolt) to remove a clutch from an '84-'87 (KF82) motor? I can't find any reason it wouldn't work. I don't want to buy the tool and then have it not work.
I read somewhere that you can run a clutch from an '88 and up cart on an '84-'87 motor as long as you use the original inner pulley from the old setup. |
Re: Clutch Removal Bolt Tool - KF82
you can make your own puller. just get a thin bolt that goes in the shaft and cut it to the threads and then get a bolt that will screw in against it and it will push it right off. My friend was trying to make one by welding two bolts together when we realized you can use two pieces. Make sure the thin one does not touch the inner threads.
|
Re: Clutch Removal Bolt Tool - KF82
Quote:
|
Re: Clutch Removal Bolt Tool - KF82
Use a ratchet extension. Go look at the other post where you were asking about it. I see no reason why it wouldn't work...
http://www.buggiesgonewild.com/gas-c...tml#post774097 |
Re: Clutch Removal Bolt Tool - KF82
I own one and have used it once and it worked just fine.
Jason |
Re: Clutch Removal Bolt Tool - KF82
Finally got her running today. See video here:
http://www.buggiesgonewild.com/membe...-club-car.html |
All times are GMT -5. The time now is 10:59 PM. |
Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
This Website and forum is the property of Buggiesgonewild.com. No material may be taken or duplicated in part or full without prior written consent of the owners of buggiesgonewild.com. © 2006-2017 Buggiesgonewild.com. All rights reserved.