2022 ICON Controller Parameters.
Figured I would start a thread where everyone can post their findings when playing with the parameters of the new 2022 icon controllers. Post what you changed and the result. Also be a good place to post explanation in layman’s terms what exactly each parameter does as they are figured out.
|
Re: 2022 ICON Controller Parameters.
Good call. I’ve got the parts on the way to make my cable. My main priority is to improve drivability, right now I feel like the regenerative braking is set too high, and the throttle response is too aggressive. The only time I want to be thrown back in my seat is if I floor it.
I’ll share my results. Sent from my iPhone using Tapatalk |
Re: 2022 ICON Controller Parameters.
8.3.1 is the parameter for the regenative braking. It’s
Most likely set to “1” if you change it to a “2” it turns it off. |
Re: 2022 ICON Controller Parameters.
Quote:
|
Re: 2022 ICON Controller Parameters.
Quote:
Quote:
|
Re: 2022 ICON Controller Parameters.
Quote:
|
Re: 2022 ICON Controller Parameters.
As far as increasing the speed I am told it’s done different than the old Toyota/NEOS controllers. On the neos controllers you just raise the max motor rpm’s. I’m told on these new 2022 icon controllers you need to adjust the k/mh. Don’t know the exact parameter yet.
|
Re: 2022 ICON Controller Parameters.
Quote:
When admin, rpm’s show up on the speed menu. |
Re: 2022 ICON Controller Parameters.
1 Attachment(s)
Can anyone direct me on steps to make changes in the new ICON software?
There is not a blank Colum to input changes like the older NEOS software? I have a communication green light and it is reading info on new 22 cart. how do I input the changes and send to controller? All I want to do is increase the speed from 22mph to 29-30ish. any help would be appreciated. |
Re: 2022 ICON Controller Parameters.
Will do.
I guess my question is how to make the changes to controller to even see if you get gains. I try to upload changes, then download, ect... uplug from comp. turn off key. wait. turn on key plug back in and settings reset to original RPM (37.9) .... so I am assuming I am not doing in correct steps and data is never reaching the controller? |
All times are GMT -5. The time now is 01:40 AM. |
Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
This Website and forum is the property of Buggiesgonewild.com. No material may be taken or duplicated in part or full without prior written consent of the owners of buggiesgonewild.com. © 2006-2017 Buggiesgonewild.com. All rights reserved.