|
how to remove clutch assembly?
91 , ezgo two cycle gas ,I am finally getting caught up enough to work on it some more. I take the bolt out of the crankshaft on the belt /clutch side but can't seem to figure out how to remove the assembly .Does the clutch cover need to come off?
Thanks for all the help ,this is harder than building hot rods.:roll: |
Re: how to remove clutch assembly?
|
Re: how to remove clutch assembly?
WOW $40 !! I'll just have to try something else. Thanks anyway.
|
Re: how to remove clutch assembly?
Most clutches have 3/4" fine threads. I have found one that was smaller. Pack the hole full of grease, and thread the big bolt in on top of the grease. The hydraulic action will pop the clutch.
|
Re: how to remove clutch assembly?
Quote:
|
Re: how to remove clutch assembly?
I don’t recall how long it took me the first time but this go around, I had the clutch of in 35-40min........I know it took me much longer the first time!
|
Re: how to remove clutch assembly?
With the clutch puller it takes longer to loosen the starter belt than to actually pull the clutch.....
|
Re: how to remove clutch assembly?
I didn’t use a puller, just a rod and 3/4” bolt...and impact of course
|
Re: how to remove clutch assembly?
Yep ,a 1 inch fine thread bolt did the trick . it jumped about a foot when it come loose . I'm cleaning parts now in between all the other work that needs done , Thanks again for the help .
|
| All times are GMT -5. The time now is 07:19 PM. |
Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
This Website and forum is the property of Buggiesgonewild.com. No material may be taken or duplicated in part or full without prior written consent of the owners of buggiesgonewild.com. © 2006-2017 Buggiesgonewild.com. All rights reserved.