Hard starting 95 ezgo gasser....please help!!
 

Guys, I have a 1995 ezgo gasser. It has gotten real hard to start but once it gets to going it will run fine. I have to just barely eaze into the throttle ever so lightly to get it to fire up. Doesn’t seem to matter if its hot or cold, first time starting or been driven all day.

I’ve replaced the plugs, set the valves, new fuel pump, etc. I finally took off the carb and cleaned it up good and that seemed to help for a few days but then it’s back to doing it again. Any idea what could be wrong with it? Is there something in the carb or bad gas? Or was me cleaning the carb just covering up some other problem? Let me know your thoughts please on what to check. Thanks!!

Re: Hard starting 95 ezgo gasser....please help!!
 

Did you check the compression?

Re: Hard starting 95 ezgo gasser....please help!!
 

Check your float level.

Re: Hard starting 95 ezgo gasser....please help!!
 

You might clean out your fuel pump and check the pulse line for some blockages. Also check the feed line into the tank for any cracks as well as the fuel cap to make sure it is venting properly.

Re: Hard starting 95 ezgo gasser....please help!!
 

I finally took off the carb and cleaned it up good and that seemed to help for a few days but then it’s back to doing it again

It may need it again???

Re: Hard starting 95 ezgo gasser....please help!!
 

If you haven' done it yet put a new fuel filter on!

Re: Hard starting 95 ezgo gasser....please help!!
 

Have you checked the float level. Mine was acting the same till i adjusted the float.

Re: Hard starting 95 ezgo gasser....please help!!
 

Thanks guys. I will check the float level.