Just bought old gas cart
Lot of questions?
year?-Plate # 80010 and 205760 3 wheels .Robin engine,all metal body. I was told Runs only when hand is over carb inlet. Do I need to rebuild carb? is this a 2 cycle engine? ratio(oil to gas)if it is? |
Re: Just bought old gas cart
Hellop Gardner,
I do'nt know the engine, but in your case it doesn't matter for the problem. Your problem is a lean mixture, so the air - fuelratio isn't right. It gets not enough gas or to much air. When you hold your hand before the inlet, you are getting less air in the carb / engine. Not enough gas: Clean the gasline from tank to the inlet and look if the floater and its valve is in good shape. Does the fuelpump work proper? To much air: Is the carb closed when stationairy running? 2 Stroke: Are the seals tight, so not leaking air , around the cranck. Is the lower seal under the cilinder allright, not leaking. Is there a airleak between carb and engine? Benno |
Re: Just bought old gas cart
if your planning on keeping it i would just spend the money and tear it down. put all new gaskets and crank seals in it and give the carb a good cleaning. you'll be much better off in the long run. if it has a leak you will trash the bearings and/or burn it down....
|
All times are GMT -5. The time now is 10:13 AM. |
Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
This Website and forum is the property of Buggiesgonewild.com. No material may be taken or duplicated in part or full without prior written consent of the owners of buggiesgonewild.com. © 2006-2017 Buggiesgonewild.com. All rights reserved.