Gas Club car precedent governor issue
Hey folks. I have a 2011 gas precedent. I was going to adjust the governor by taking the small nut off and turning the pin. Unfortunately I took the nut all the way off and took the little cotter pin out and the little pin fell down into the hole. The dealer says the case has to be split to get it out. Is there any way I can get the little pin out without splitting the case open?
|
Re: Gas Club car precedent governor issue
Can you still see the top of the shaft in the hole?
If it fell in all the way, the only way to get it back is to open the case. They must have changed something because I don’t think it’s that easy to lose to governor lever on the older transmissions. The other end of that pin makes about a 70° bend and has a flat that engages the governor wheel inside the transmission. So it could have stopped part way in if it hit something near the governor wheel, but I don’t remember there being much in the way in that part of the trans. Likely it fell in and is wedged against the intermediate shaft somewhere. |
Re: Gas Club car precedent governor issue
I can’t see it but I can feel it when I stick a small screwdriver in there. It’s not very far down there. Would a magnet pull it back up?
|
Re: Gas Club car precedent governor issue
try attaching a strong magnet to the screwdriver shaft and see if you can then pick out the the governor shaft.
|
Re: Gas Club car precedent governor issue
Man that sucks, was thinking about messing with mine and I can see that cotter pin, 2008 model, This is all new to me and I'm getting 22mph now so I'm good for now. Good Luck and keep us posted on how it goes.
|
Re: Gas Club car precedent governor issue
Bassdeer, how were you able to get 22mph out of yours?
|
Re: Gas Club car precedent governor issue
Try using a 1/8" or 3/16" dowel and superglue it to the top of the shaft and try to gingerly raise it that way.
|
Re: Gas Club car precedent governor issue
Quote:
|
Re: Gas Club car precedent governor issue
I tried a magnet. No dice. I think that piece may be aluminum. Super glue wasn’t strong enough to hold. Going to try a dab of epoxy at the end of a tiny dowel and see if I can pick it up. If that fails I may have no choice but to take it in to have the case split.
|
Re: Gas Club car precedent governor issue
Does anyone know if that case can be split open without removing the whole axle from the cart?
|
All times are GMT -5. The time now is 10:09 AM. |
Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
This Website and forum is the property of Buggiesgonewild.com. No material may be taken or duplicated in part or full without prior written consent of the owners of buggiesgonewild.com. © 2006-2017 Buggiesgonewild.com. All rights reserved.