Motor low power…. Kinda…. i will do my best to explain
I have an 1993 ezgo TXTDCS with the nine pin 12O6XS controller.
I will do my best to explain the issue I’m having because it seems a bit odd. I have no power when the wheels are on the ground, if I jack up the rear end and put it in reverse I have a very weak rotation into reverse. If I switch it to forward all I get is a humming and slight vibration from the motor the motor is not spinning. I have full battery pack voltage, batteries are brand new. Brakes are not locked up. Every connection is as tight as it can be. In my troubleshooting I did notice if I swap the F1 and F2 wires on the controller I appear to have full power in reverse no matter where the direction shifter is located. It gives me full power in forwards and full power in reverse if I have those wires swapped. But when I put them back to where the wiring diagram shows they should be I have the same issue I described. Any help is much appreciated |
Re: Motor low power…. Kinda…. i will do my best to explain
Replace the controller with Alltrax XCT400DCS and 200 solenoid.
Expect 30% more power and speeds of 22-23mph with stock 18" tires. |
Re: Motor low power…. Kinda…. i will do my best to explain
I just put a new controller in it and a new solinoid
|
Re: Motor low power…. Kinda…. i will do my best to explain
Quote:
|
Re: Motor low power…. Kinda…. i will do my best to explain
I did, remanufacted through fsip.
I did call them today to confirm it was under warranty if that ends up being the issue. |
Re: Motor low power…. Kinda…. i will do my best to explain
Quote:
|
All times are GMT -5. The time now is 09:32 AM. |
Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
This Website and forum is the property of Buggiesgonewild.com. No material may be taken or duplicated in part or full without prior written consent of the owners of buggiesgonewild.com. © 2006-2017 Buggiesgonewild.com. All rights reserved.