Re: 13hp clone
 

i got my 13hp clone for 318.00 to the door from carroll stream ayear ago.its red so looks just like the real thing. finally got the time to put it in after having the crank turned to match the clutch for 50.00 bucks. runs great eyeballed the allianment drilled four holes and bam it works great except i got the belt alittle tight have to shut it off to put it in gear.

Re: 13hp clone
 

my old flat head was in parts with no air box .carb and i dont no what else missing. looks like piston rod broke.didnt hurt block any.

Re: 13hp clone
 

I bought one last Friday from Harbor Freight they have a 'new' store here and it was on sale for 299 , and it still hits the gear head on the rear end just like the opposed twin 18 did . may not even be able to use it on this project . but it don't eat nothing to sit there .:lol:

Re: 13hp clone
 

In The Carryall2 I Have Half Inch Clearence Between Rearend. I Would Like A16 Or 18hp In This At Some Time. P.s Hello From Cook County Goat.

Re: 13hp clone
 

Ga nut check your PM

Re: 13hp clone
 

According to Aaron, after you get those little motors tuned out good it runs like a champ. Says it runs better than his vanny, but I don't konw about that. :lol:

Re: 13hp clone
 

:?:?:?4by4 It Seems To Go Preety Good. But I Have Some Bugs To Work Out Like What That Small Arm With The Sping Is On The Rearend Is.andim Being Easy On It For The First Few Hours ......while Im Here Goat I Responded To Your Pm I Dont Know If It Made It Or Not? Im A Newbie At This Also. Im Computer Alitteridiot(dumb).

Re: 13hp clone
 

Small arm on the rear end should be the govenor. Shoot me a PM if you have more questions. :thumbup:

Re: 13hp clone
 

Hey guys hoping you can help me out. I found a used Honda GX390 13hp motor. Would I be able to bolt this right up to the factory mounts without huge modifications to a 1995 Club Car? It had the Kawasaki FE290 motor. It's pretty inexpensive and wondering what I'll need to do to make this work.

Can anyone help?

Re: 13hp clone
 

Look under your thread!! You'll need a new mounting plate and some clutch mods. Nothing serious though.