How do I wire start and run with a key instead of pedal start/stop
Greetings,
I just purchased a 2009 Gas Club Car Precedent and would like to wire it to start and run with a key switch instead of using the gas pedal switch. Any assistance on this modification would be appreciated. Thanks! Trent |
Re: How do I wire start and run with a key instead of pedal start/stop
There is a thread in clone engine swap called "wiring ignition to turn off engine". It worked for me very well. Not sure if the precedent is the same though.
|
Re: How do I wire start and run with a key instead of pedal start/stop
|
Re: How do I wire start and run with a key instead of pedal start/stop
Lift up the rubber floor mat. Lift up the plate that covers the wiring in front of the gas pedal. There are 5 wires running from the 2 microswitches inside the pedal assy. Clip the black/white wire. Tape off the ends. Turn up the idle screw on the carb a touch. Everything works flawless. Turn on key and step on gas to move. Turn off key to shut off.
|
Re: How do I wire start and run with a key instead of pedal start/stop
:thumbup:
Quote:
|
Re: How do I wire start and run with a key instead of pedal start/stop
Can this mod be done on a new Onward gas cart?
|
All times are GMT -5. The time now is 02:56 AM. |
Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
This Website and forum is the property of Buggiesgonewild.com. No material may be taken or duplicated in part or full without prior written consent of the owners of buggiesgonewild.com. © 2006-2017 Buggiesgonewild.com. All rights reserved.