|
speed control wiring
I have a 36 volt ez-go date code L0906, serial # 2435565. The wiring to the speed control melted. I replaced the speed control. I need to know which color wire connects to which terminal on the control. The connector was fried so I need to connect them individually.
|
Re: speed control wiring
1 Attachment(s)
If the Molex 5 pin connector has melted you can connect to an Alltrax AXE or SPM control via the spade connectors.
#1 = red #2 = Black #3 = white #4 = orange #5 line up pin not used NPX controls differ ... See my controller install sheet below |
| All times are GMT -5. The time now is 05:21 PM. |
Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
This Website and forum is the property of Buggiesgonewild.com. No material may be taken or duplicated in part or full without prior written consent of the owners of buggiesgonewild.com. © 2006-2017 Buggiesgonewild.com. All rights reserved.