Re: DCS solenoid wont click cart stalls
In the cart is best place to run test. The problem seems to be the controller is not energizing the solenoid. Try this, verify blue wire not getting negative (0 volts) when pedal is pushed. If not disconnect the blue wire from the solenoid and run a small jumper from Battery - and touch it briefly to the solenoid where the blue wire was removed. if the solenoid clicks connect jumper temporary and see if the cart performs like it should. The solenoid should click and the cart run normally otherwise. If it does make sure the blue wire is good to pin 7 on controller and it does not have voltage on it. Use caution running these test that you don't run into over something.
I see JohnnieB replied to your post too while I was figuring out what to do next. He is very knowledgeable. I will turn you over to him for assistance.
|