View Single Post
Old 10-05-2018, 02:05 AM   #26
cgtech
Over This Interview Is...
 
cgtech's Avatar
Yamaha
 
Join Date: Jun 2012
Location: AZ
Posts: 17,449
Default Re: G16 input shaft replacement

Ok, assuming detent ball is present, the normal screw setting i have seen is 4.5, occasionally 5, or rarely 5.5. if it were me, I would always default to 4.5, because that's what 90% of them are. Next, shift cables, after slipping them on the splined shaft (but before putting the cables back in place), make sure that manually moving the lever at the transmission results in same angles in forward and reverse positions. It can be installed one spline off, and still work, but poorly.
cgtech is offline   Reply With Quote