View Single Post
Old 03-20-2009, 09:39 AM   #16
richie
ZZGONE
 
richie's Avatar
E-Z-GO
 
Join Date: May 2008
Location: central florida
Posts: 656
Default Re: rebuild the shop cart

If you remove the front cross mount all together and cut all the extra crap off the rear,you could run a plate like I did and possibly get away without lenghtening the swingarm.Do away with the rubber mounts also.You could go to a one cable set-up and that would free up the area where the cables mount(get rid of that bracket).Check out my pics of my set up out of the cart(page 2).Maybe it can give you some kind of idea.It is easiest to do if you pull the swingarm out of the cart.Depending on what kind of bend you put in the engine plate will determine how high the engine sits under the seat.Good luck P.M. Looking good
richie is offline   Reply With Quote