Governor Adjust on 2010 Ezgo Workhorse 1200G
Hello,
My apologies if this was already covered.
I just bought a Workhorse 1200 with a Kawasaki gas engine and I am trying to adjust the governor to gain a little more speed.
I have reviewed the posts that cover the nuts on either side of the spring. My linkage does not however look like this.
My linkage consists of a spring on the end of the throttle cable connected to an adjustable bracket.
I have adjusted the bracket with some success, but after reading about other manufacturers linkages it occurs to me this evening that I may need to take the slack out of the throttle cable to get better success.
Is there anyone out there that is familiar with adjusting this setup?
I have installed a tachometer to ensure I do not over-rev the engine. I am assuming that I should not exceed 4k rpm on the Kawasaki engine.
Thank you for any input. Just farm use, not looking to race, just more speed between chores.
|