Buggies Gone Wild Golf Cart Forum - View Single Post - 1999 Gas EZGO High Speed Gear install 8:1

JPonLKN · 09-05-2020, 09:05 PM

At this point, is simply reassembly. Make sure both case mating surfaces are clean and smooth, put gasket maker on one of the mating surfaces,, and slide the top half of the case back on, make sure you get the two long bolts back where they belong, and bolt the case together. Install the Axle tube and five bolts, drop the axle back in, and re-install the c-clip.

Install brake back plate, and then drum, and re-install the axle back under the cart, hook up the brakes, and either re-install the factory motor mount, or whatever motor mount you are using moving forward.

Good luck....Hope it helps.

09-05-2020, 09:05 PM	#5
JPonLKN Gone Wild Join Date: Jul 2020 Location: NC Posts: 773	Re: 1999 Gas EZGO High Speed Gear install 1:8 At this point, is simply reassembly. Make sure both case mating surfaces are clean and smooth, put gasket maker on one of the mating surfaces,, and slide the top half of the case back on, make sure you get the two long bolts back where they belong, and bolt the case together. Install the Axle tube and five bolts, drop the axle back in, and re-install the c-clip. Install brake back plate, and then drum, and re-install the axle back under the cart, hook up the brakes, and either re-install the factory motor mount, or whatever motor mount you are using moving forward. Good luck....Hope it helps.