View Single Post
Old 09-27-2014, 06:17 AM   #9
JohnnieB
Techno-Nerd
 
JohnnieB's Avatar
E-Z-GO
 
Join Date: Jun 2011
Location: West Virginia
Posts: 16,828
Default Re: My cart wont move. Please help with troubleshooting

Quote:
Originally Posted by cableguy_hd View Post
In reading another thread I was wondering if it could be in the plunger ITS area? Also in Johnnie's first response he asked me to check B- & M- and the voltages should be the same... since they were what was my next step? I'm going out now to look at the F/R
If you get full pack voltage between B- and M- when the solenoid first clicks, slowly push pedal to floor. (Cart on jackstands)

Voltage should smoothly decrease to Zero.

If it does, the motor should be turning or something ought to be getting hot. A lot of amps are going someplace.

If it doesn't, either the controller is not getting the proper signal from the throttle or the controller is bad.
JohnnieB is offline   Reply With Quote