Quote:
Originally Posted by BobInDaytona
Attached are a couple of pictures of the cable I made.
One shows the pinout on the device, one shows the end of the cable, and one
is a hand drawing of which wire goes to which pin - the labels rx,tx,vcc,gnd match the labels on the circuit board on the device.
The 4 pin ribbon cable that is attached to the device comes with it...
This is the same molex connector that is used on the NEOS cable.
|
Bob does it have to use this FDI adapter or would a standard Serial to rs232 adapter work with a db9 connected with the mating molex connector?