Buggies Gone Wild Golf Cart Forum - View Single Post

AirJunky · 10-31-2012, 10:39 AM

Mine is no where near stock. But the things I've done to get rid of some noise include:
-replacing all the plastic fasteners in the fender flares & dash with SS machine screws & nylock nuts.
- go thru the cart & tighten screws & nuts down.
- pull up the diamond plate floor & install a thin rubber mat between the diamond plate & the steel subfloor.
- run low tire pressure.... as I recall it's 6 psi in front & 8 psi in the rear.
- welded up the roll cage (aka; upper brush guard). It was a 5 pc unit all bolted together. Now it's 1 pc & solid.

Hard to hear much over the Honda & the ATV tires but it definitely made a difference, especially off road.

10-31-2012, 10:39 AM	#7
AirJunky Gone Wild Join Date: Jul 2009 Location: Liberty Lake, WA. Posts: 1,762	Re: Ezgo Off Road Cart. Rough Ride. Rattle Mine is no where near stock. But the things I've done to get rid of some noise include: -replacing all the plastic fasteners in the fender flares & dash with SS machine screws & nylock nuts. - go thru the cart & tighten screws & nuts down. - pull up the diamond plate floor & install a thin rubber mat between the diamond plate & the steel subfloor. - run low tire pressure.... as I recall it's 6 psi in front & 8 psi in the rear. - welded up the roll cage (aka; upper brush guard). It was a 5 pc unit all bolted together. Now it's 1 pc & solid. Hard to hear much over the Honda & the ATV tires but it definitely made a difference, especially off road.