No output on 488 amp. controller
I have a 96 ez-go, lifted, stock motor, 488 amp.controller, 4 ga. cables, and a up graded f/r. switch. It is dead in the water. I can't get any voltage reading out of controller that is 16 months old. I think it needs to be replaced. Got controller from buggies unlimited. I think it is a Curtis on a 1204 footprint. I would like to get it rebuilt if possible, or do I just need to bite the bullet and get a new one? Does anyone one have any suggestions? The motor runs in forward and reverse if I bypass controller.
|