View Single Post
Old 05-16-2011, 07:55 AM   #22
no clue
madoc1's Avatar
Join Date: Sep 2009
Location: spicewood, texas
Posts: 3,308
Default Re: "Early 90's EZGO - Needs a Rebuild"

you need to pull the plug and with the wire still attached, ground the electrode (tip) to the engine block and spin the engine over. if you have spark, you will see it and it should look bluish. while you have the plug out, it's a good time to ckeck the compression. and no, it should not turn over with out pressing the gas. there is a small box down low under the drivers seat. pull the cover off and make sure the micro swiich is moving freely. with the key on you should have 12volts to one side. then when push the pedal it will close that swtch and send power to the solenoid. it could be stuck closed somehow.
madoc1 is offline   Reply With Quote